|
Frequently Asked Questions |
1.) QUESTION: Open circuit voltage 12.4V Cordless case 'tan is low, what do you do?
ANSWER: Ampere Battery 1 / 20 amps should be connected to the supply charge.
2.) QUESTION: On board the reason for the Battery Voltage is over 13' V?
ANSWER: Batteries are discharging acid into the acid was placed.
3.) QUESTION: Car Battery Voltage 14.2 to 14.5 volts or above is the reason?
ANSWER: The tool is defective in konjektor, there is excessive Battery charger lights.
4.) QUESTION: Car Battery Voltage 13 Volta is not on what is the reason?
ANSWER: Konjektor or charger is damaged.
5.) QUESTION: Car Battery Voltage 13.5 volts on the top did not come in, because what is it?
ANSWER: The Diyods charger is one of the outbreak.
6) QUESTION: Battery is defective; tools on how to measure the effects?
ANSWER: The negative impact. It is the tool that should be measured by putting a new battery.
7.) QUESTION: car tick over 13 konjektör when the voltage is high Voltage; What is the reason?
ANSWER: Konjektörü is defective.
8.) QUESTION: indicators (magic eyes) in the new battery does not show green what to do?
ANSWER: indicators of the ball may be inserted. Left to right instead of the battery is waved.
9.) QUESTION: Batteries of the label that wrinkle paint color is distorted because the screen is?
ANSWER: Battery has been charging excessive.
10.) QUESTION: Dual battery using one of the vehicles battery voltage is low What is the reason?
ANSWER: The Batt is one of the 12 Volt current is drawn. Stop charging the battery at the other extreme.
11.) QUESTION: Dual 12 Volt battery using current to get the vehicles should be doing?
ANSWER: The circuit from the battery flows to the two should be Converter.
12.) QUESTION: Positive Negative eyes, starting from the right eye and a rising intensity of acid value is measured is the reason?
ANSWER: Chassis cable olmuş oxide or battery can not get enough chassis.
13.) QUESTION: Acid color transparent white, not color of coffee is the reason?
ANSWER: Batteries can be seen over-charging, battery life was ended to the electrolyte plate and not in the active substance is filtered.
14.) QUESTION: The first acid accumulator battery voltage of 12 volts to be water below; What is the reason?
ANSWER: Before the battery 1 / 20 to connect the charging current to the end of 1 hour battery charge should be removed from the warming and the voltage is 12 volts on the battery in damp took gold in the 12 Volt battery in the opposite eye is mounting means.
15.) QUESTION: normal working day is not printed Battery morning What is the reason?
ANSWER: Batteries should be checked and voltage of the battery acid bomen is not a problem in the infallible tool Konjektor, Anthem Dinamo and diesel vehicles and heating should be looking at spark plugs.
16.) QUESTION: Dual battery using vehicle battery connections to what should be considered?
ANSWER: Oxide does not have to, not the opposite polarity and one head attached to the battery should be careful not to be taken from the stream.
17.) QUESTION: Tool is using a one-time customer per month; battery what?
ANSWER: Battery standby time due to the tool can become lost. And they are waiting a long time (calcification) is. For this reason, vehicle type 15 days, a week in winter and should be working most 10 minutes to charge the battery must be completed.
18.) QUESTION: I connect the Battery to the battery charging current bomen not too low, the battery is bad is it?
ANSWER: Indeed the battery may not be corrupt; Battery completely discharges is 1 / 20, not to flow, for example, is 60 amps battery, connect the charger and 20-25 Ampere (lightning charge) Battery voltage begins to rise 10 Amps should be reduced to 2 hours to charge these valuations should continue 1 / Current 20 Amps with 3 battery with full capacity reached so that, until, until the charge density must be reached to the 1280 gr/cm3.
19.) QUESTION: Battery acid is frozen what should I do?
ANSWER: This is definitely the battery charger is connected to the first .1; + 40 C 'then do not pass within the container filled with hot water in the battery will not enter the water, the acid in the battery must be solved. They must be connected to the charger.
20.) QUESTION: When inserting the battery to LPG vehicles should be considered what?
ANSWER: Car; karbirator Is Normal? Do Semi injection? Do you have to determine with full injection is needed. Because: LPG 'li olupta normal and part karbiratörlü injection of the vehicle running gasoline should be working, contact a closing position before the switch to gasoline and gasoline karbirator full must be provided. In this case the car easier and will work as well as battery-for overloading the battery will last longer will be used. Full injection tools in the tool itself runs and gasoline to LPG automatically pass.
21.) QUESTION: What do you warm up the battery to battery acid, we need to put?
ANSWER: Battery has taken moisture into the battery cover on the cold water and refrigerate up to + 25 C is a must. Subsequently 1 / 20 is necessary to connect the charger.
22.) QUESTION: charging battery acid will not be?
ANSWER: No! First, the decrease has absorbed Separators and records of the maximum level of acid is complete and up to ½ hour after waiting to connect to the charger.
23.) QUESTION: Can we use COMMERCIAL TAXI DE normal battery?
ANSWER: No you can not use.! And 72 amps should be used TAXI BATTERY.
24.) QUESTION: Bus can also use the battery?
ANSWER: Buses manufactured batteries should be used for.
25.) QUESTION: What is being measured should be noted battery bomen?
ANSWER: bomen drawn into the electrolyte is completely in the glass bar at the top level bomen value and gives the wrong value for him; electrolyte phase to phase should be able to read normal value. So easy to get accurate results with bomen.
26.) QUESTION: Dry battery indicator green, but not new electrolyte filled what should I do?
ANSWER: Acid water level control. Connect the charger still does not go green, the battery to the left to the right due to shaking or vibration of the tool itself will come to the green itself after a while.
27.) QUESTION: Diesel vehicles in the normal battery voltage bomen and tools do not work What is the reason?
ANSWER: Diesel car's spark plugs for heating may be defective. The spark plugs should be changed. Accumulator is solid.
28.) QUESTION: Battery tools dismount polar heads which are attached to or inserted must be disassembled?
ANSWER: Battery tools are detachable from the negative cable end to be disassembled, while the positive cable plug must be plugged end.
29.) QUESTION: What are the cable ends spliced to the pole should be aware of?
ANSWER: polar heads on the + and - signs should be considered, and + pole is greater than head diameter. Or incorrectly installed per pole mounting the battery + (-) to - (+) or the vehicle's electronic system and electronic brains connected lights. Batteries may also explode
30.) QUESTION: Batteries are not used in the electrolyte we can shed?
ANSWER: I can not shed. First, the battery discharge until reaching full capacity and can be charged back monthly checks should be a voltage of the battery voltage falls below 12.4V, and V are to be charged again.
|
